Skip to content
Rev0 Wiki archive

SNA

Last edited

Contents
  1. Summary
  2. Testing
  3. Revisions
  4. Bill of Materials (v1.0)
  5. PCB/Construction Photos

This page describes the rev0SNA 50-2500 MHz Scalar Network Analyzer (SNA).

Summary

Schematic for the rev0VTx VCO.
Board for the rev0VTx VCO.

The rev0SNA is based around three primary modules: the 1st Local Oscillator, Power Detector, and Directional Coupler/Reflectometer. The 1st Local Oscillator is used as a signal generator, which passes through the directional coupler/reflectometer to port 1. The DUT is placed between port 1 and port 2. Port 2 connects to the power detector, which can be switched between measuring the Thru (S21) and Reflect (S11) powers, coming either from port 2 or the output from the directional coupler/reflectometer.

Block diagram showing the basic functional blocks and expected power levels at each stage in the SNA.

Testing

  • 10.31.2013:

Revisions

  • 1.0: Initial revision.

Bill of Materials (v1.0)

PartQuantityUnit CostTotal CostSource
SA_LO11$46.82$46.82rev0SA 1st LO
SNA_PDet1$20.57$20.57rev0SNA Power Detector
SNA_DCpl1$59.72$59.72rev0SNA Directional Coupler
SNA_DBridge1$59.72$59.72rev0SNA Directional Bridge
SNA_TRSwitch1$8.00$8.00rev0SNA Thru/Reflect Switch
SNA_Controller1$20.00$20.00rev0SNA Controller/LCD
Total Unit Cost$147.11

PCB/Construction Photos