Skip to content
Rev0 Wiki archive

SA LPF

Last edited

Contents
  1. Summary
  2. Testing
  3. Revisions
  4. Bill of Materials (v1.0)
  5. PCB/Construction Photos

This page describes the input/TG low-pass filter for the DIY Spectrum Analyzer.

Summary

Schematic for the input LPF.

The input must be low-pass filtered to allow only the desired passband of 30MHz-2.5GHz through to the rest of the system. Likewise, the tracking generator must have an output low-pass filter to prevent LO and IF feedthrough at 3.5-6GHz. The low-pass filter is a 7-pole Chebyshev lumped element design, chosen for its performance, size, and simplicity. The filter has a -3dB bandwidth of 2.57GHz, with 50dB of rejection at the 1st IF of 3.5GHz, and >50dB rejection through 8.5GHz.

Testing

  • 8.6.2013: The filter was designed and simulated in Qucs using S2P part definitions from Murata's SimSurfing utility. Results of the simulation are shown below.


Frequency (MHz)Power (dBm)
150-0.06
200-0.02
250-0.03
300-0.07
350-0.06
4000.03
4500.04
5000.02
550-0.07
600-0.07
6500.05
7000.09
750-0.05
800-0.03
8500.02
9000.00
950-0.07
1000-0.10
1500-0.17
20000.21
25000.04
30000.62
35001.72
40001.47

Revisions

  • 1.0: Initial revision.

Bill of Materials (v1.0)

PartQuantityUnit CostTotal CostSource
ADF43501$12.02$12.02Digi-Key
FOX924B-10.0001$3.76$3.76Digi-Key
ADP1241$1.95$1.95Digi-Key
AP11151$0.54$0.54Digi-Key
MSP430G25531$2.58$2.58Digi-Key
0402 100nF Capacitor10$0.011$0.11Digi-Key
0402 10pF Capacitor10$0.0116$0.12Digi-Key
0603 Capacitor9$0.0096$0.09eBay - mib_instruments
0603 4.7uF Capacitor3$0.1484$0.45Digi-Key
0805 10uF Capacitor1$0.30$0.30Digi-Key
0603 Resistor10$0.00294$0.03eBay - mib_instruments
0603 Green LED1$0.10$0.10Digi-Key
0603 Red LED1$0.27$0.27Digi-Key
0603 Ferrite Bead (470 Ohm)2$0.0472$0.09Digi-Key
Male Header8$0.01$0.03eBay
SMA Female Connector4$3.37$13.48Digi-Key
PCB1.75"x1.1"/3$10.00$6.42Laen's PCB
Total Unit Cost$42.32

PCB/Construction Photos