X2 Mill: Difference between revisions
No edit summary |
|||
| Line 1: | Line 1: | ||
[[File: | [[File:Mill_with_vise.jpg|thumb|right|Current state of mill.]] | ||
This page documents the setup and modification of the [http://www.harborfreight.com/two-speed-variable-bench-mill-drill-machine-44991.html Harbor Freight Mini Mill] (Sieg X2 Clone). | This page documents the setup and modification of the [http://www.harborfreight.com/two-speed-variable-bench-mill-drill-machine-44991.html Harbor Freight Mini Mill] (Sieg X2 Clone). | ||
==3D Model== | ==3D Model== | ||
Revision as of 01:06, 6 December 2015
This page documents the setup and modification of the Harbor Freight Mini Mill (Sieg X2 Clone).
3D Model
...
Setup/Modifications
11/12/2012 - Harbor Freight Mini Mill arrives; damaged in shipment, both hold-down bolts came loose and the unit was dropped on the Y axis jamming the notch into the bearing/sleeve thus preventing any movement of the Y axis. Contacted customer service who made a note to return the mill to a local store and get a receipt to place a replacement order.
11/13/2012 - Damaged mill returned to Harbor Freight.
11/16/2012 - Replacement mill ordered by phone, shipping charge was waived since it was not refunded by the store with the damaged unit return.
11/20/2012 - Replacement mill arrives, was only held down with one bolt (which was loose), but undamaged. Stripped down unit, cleaned, and lubricated Y and X axes and adjusted gibs.
11/22/2012 - Stripped and cleaned Z axis/mill head, lubricated and adjusted gibs, and partially mounted unit to bench. Removed power supply box from back as it interfered with the shelf on the bench.
11/30/2012 - Fully mounted unit to bench, re-adjusted gibs.
12/4/2012 - Mounted and squared vise, adjusted motor gear meshing, re-attached baffles, removed drill chuck and attached 3/8" R8 collet. Made first cuts in aluminum (shown below).
Photos
...
